Grizzly H6144 Uživatelský manuál

COPYRIGHT © FEBRUARY, 2005 BY GRIZZLY INDUSTRIAL, INC., REVISED DECEMBER, 2007 (TS)WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE O

H6144 34° Angle Finish Nailer–2½"-9-OPERATIONSLoading When replacing nails in your Model H6144, follow these guidelines:Gauge: 15Length: 1

H6144 34° Angle Finish Nailer–2½"-10-Figure 5. Depth adjustment knob. Besides damaging your workpiece, deflection can cause injury if your fr

H6144 34° Angle Finish Nailer–2½"-11-The most frequent situation with any type of nailer is a nail jam. A jammed nail must be cleared before us

H6144 34° Angle Finish Nailer–2½"-12-Replacing Pistons/O-RingsIf you use your nailer day in and day out, repair pistons are cheap in

H6144 34° Angle Finish Nailer–2½"-13-CLEANING & LUBRICATION CleaningUse a good solvent to clean the nose assembly of the nailer. A

H6144 34° Angle Finish Nailer–2½"-14-H6144 PARTS BREAKDOWN 

H6144 34° Angle Finish Nailer–2½"-15-H6144 PARTS LIST REF PART # DESCRIPTION REF PART # DESCRIPTION1 PH6144001 SPECIAL CAP SCREW M5-.8 X 12 45 PH

H6144 34° Angle Finish Nailer–2½"-16-1. O-rings must be replaced & operation of safety yoke must be checked.1. Tighten screws.2. Replace O-ri

Grizzly Industrial, Inc. warrants every product it sells for a period of 1 year to the original purchaser from the date of purchase. This warranty doe

Name _________________________________________________________________________Street ________________________________________________________________

For Your Own Safety Read Instruction Manual Before Operating This EquipmentThe purpose of safety symbols is to attract your attention to po

FOLD ALONG DOTTED LINEGRIZZLY INDUSTRIAL, INC.P.O. BOX 2069BELLINGHAM, WA 98227-2069TAPE ALONG EDGES--PLEASE DO NOT STAPLEName________________________

H6144 34° Angle Finish Nailer–2½"-2--2-6. ONLY ALLOW TRAINED AND PROPERLY SUPERVISED PER-SONNEL TO OPERATE MACHIN-ERY. Make sure operation

H6144 34° Angle Finish Nailer–2½"-3-1. HAND INJURIES: Do not place your hands near the nail point of entry. A nail can deflect and tear through

H6144 34° Angle Finish Nailer–2½"-4-Operating this nailer can propel objects into the air, causing imme-diate eye damage. To protect

H6144 34° Angle Finish Nailer–2½"-5-INTRODUCTION If you have any comments regarding this manual, please write to us at the following address:Griz

H6144 34° Angle Finish Nailer–2½"-6-SET UPFigure 1. Model H6144 inventory.BCDGUnpackingYour Model H6144 left our warehouse in a carefully

H6144 34° Angle Finish Nailer–2½"-7--7-Compressed Air SystemThe Model H6144 is designed to be oper-ated at 60-100 PSI using clean, dry, regu-late

H6144 34° Angle Finish Nailer–2½"-8-Safety Yoke A safety yoke mechanism on the nose of the nailer acts as a secondary safety device.